Size Charts 

 
Wetsuits/Board   Accessories
-Aleeda   -Fins
-Body Glove   -Men's to Women's Conversion Chart

-Hyperflex

  -Gath Helmets
-Mike Stewart    H2Odyssey
-Reeflex   -Hoods
-Boards   -Gloves

 

Bodyboard Size Chart

Body Board Chart

Top


Aleeda Wetsuit Charts

Top

Flatstitch or Flatlock is recommended for warm water too, 62F and up.(In a full Suit) You can recognize this seam from the out side. This stitch looks like railroad tracks. The interior and exterior seams look about the same. The interior seam construction is flat and is more comfortable against the body then the overlock stitch. Some water may seep in through these seams too.

Blindstitch is recommended for cold water. This construction is best for cold water because the seams are glued and then stitched. This seam construction looks similar to the Flatstitch. It is narrower in the width than the flatstitch seam. The seams are glued and bonded together. The seams are then stitched. The thread and needle holes penetrate only the top area of the surface. Some seams are only stitched on one side. Very little water if any will seep through these seams.

Blindstitched with seam taping (Fluid Seal) is recommended for extremely cold water usually 50F and below. The seam construction is the same as above accept the inner seams are reinforced or covered with tape. Very little water if any will seep through these seams.


Body Glove Wetsuit Charts

Top


Hyperflex Wetsuit charts

Top


Mike Stewart Gyroll Wetsuit Charts

 

Top


Reeflex Wetsuit Charts

 

 

 

Top


Gath Helmets Size Chart

 

Top

 

Hoods Size Charts

Top


Gloves Size Charts

Top


Fins/Shoe Size Charts

 

 

Top


Men's to Women's Conversion Chart

Top